More often than not, it is used to flash stock firmware so as to fix bootloop or soft brick issues. However, there are some technical aspects of this tool, which in spite of being quite useful, doesn’t usually get the appreciation that it deserves. One among them is the ability to take a complete backup of the installed firmware on your device. But why would you need to do so? Well, upon successfully carrying out this task, you will get all the required partition files. So if any device partition gets corrupted, you could pick it up from the backup firmware and flash it via the tool or Fastboot Commands. Along the same lines, you may also use the boot.img from the backed up firmware, patch it via Magisk and flash it via Fastboot to obtain root. Well, the advantages stand aplenty. So without any further delay, let’s start off with the guide to backup your MediaTek firmware using SP Flash Tool.
How to Root any MediaTek Device Using SP Flash ToolGuide to Unbrick any MediaTek Phone using SP Flash ToolHow to Install TWRP on MediaTek using SP Flash Tool
How to Backup MediaTek Firmware using SP Flash Tool [2021]
Before starting with the instructions, make sure to take a complete device backup beforehand, just to be on the safer side. Droidwin and its members wouldn’t be held responsible in case of a thermonuclear war, your alarm doesn’t wake you up, or if anything happens to your device and data by performing the below steps.
How to Create Backup of the Entire MediaTek ROM
Using the above instructions, you were able to create a backup of a single partition. If you want to take a backup of all the partitions, then here’s what needs to be done. So with this, we round off the guide on how you could backup your MediaTek firmware using SP Flash Tool. We have shared the details for both- a single partition file as well as the entire firmware. If you have any queries relating to the aforementioned steps, do let us know in the comments section below. We will get back to you with a solution at the earliest.
About Chief Editor
